Thingiverse
Smash Cactuar Figure by AttemptingMediocrity
by Thingiverse
Last crawled date: 4 years, 1 month ago
This stemmed from an early attempt at 3D modelling in Fusion 360. I hadn't originally planned to make him into an Amiibo so I had to do the scaling after the fact in Cura. I've tried to properly scale the STL here but I haven't test printed it. If you try it please me know if it works out.
The one I made for myself was actually printed on the FDM printer in 3 parts - the cactuar was split into front and back - which led to extra filling needed.
@RyanRybot tried to print him in one piece as a test on our (then) new resin printer, and if you go this route please realize the needles are SHARP.
The offset for the 2 pieces option is 0.2mm.
The one I made for myself was actually printed on the FDM printer in 3 parts - the cactuar was split into front and back - which led to extra filling needed.
@RyanRybot tried to print him in one piece as a test on our (then) new resin printer, and if you go this route please realize the needles are SHARP.
The offset for the 2 pieces option is 0.2mm.