Slot Car Pit Lane Garage by USNSCPO

Last crawled date: 3 years, 1 month ago

1/32nd scale Slot Car scenery.
This is a modular design. Print the parts for 1 bay or 20!
There are specific components for left, right, and middle bays. Printed in PLA. The components are "keyed" to make alignment foolproof. Most pieces will require glue. I used CA/superglue, but I think I'll use hot glue in the future. Resolution and speed are not critical. This isn't an uber realistic design, so even draft quality would probably print nicely. I printed at .15 height, 60mm/s, 10% infill, from PLA, sliced with CURA.
NOTE The second floor has an overhang. Flip it over in your slicer so you don't have to use supports.
This isn't a full depth garage, more of a fascia, at about 4 inches deep. Fits really well into tight track layouts or against a back wall.
Although I envisioned this design, I didn't create the STLs. My friend Peter designed them in his CAD program. We designed the balcony and the roof billboard to accommodate Geezer's printable manufacturer's banners located here: http://slotcarillustrated.com/portal/forums/showthread.php?t=29566
Post print: I ran a file around the edges to square up everything for a nice flush fit.