Slicer Support Calibration by DiscusZ

Last crawled date: 5 years, 8 months ago

I created this as I was having issues dialing in Supports (easy removal) In doing this they snap right out. I tested this with S3D . as I was having major issues with the last layer bonding to the part.
I willadd to this design to do off the bed supports to test as well
Settings for S3D
Infill % 30
Extra Inflation Distance 1
Support Base lates 0
Combine support ever 1 Layers
Dense Support
Dense support layers 0
infil % 70
Separation from part
Horizontal Offset from part .5mm
Upper vertical separation layers 1
Lower vertical separation layers 1
These work Awesome on S3D