SkySword 70mm parts by s737500

Last crawled date: 3 years ago

Made some gear doors and an exhaust insert for the Hobbyking 70mm Skysword EDF jet.
2 types of gear doors. Simple short ones for grass field ops, and the little longer ones that cover half the wheel for hard strips.
Also made an insert for the exhaust because I did not like the step that is in the stock plane.
Will probably look into making something for the nose gear soon too :-)
I printed it all at 0.2mm layer height, 210 degrees.
Gear doors 2 perimeters, 2 bottom layers, 4 top layers, 20% infill
The exhaust must be printed in single perimeter, and 0 bottom, and 0 top layers, 0% infill.
I used spiral mode, as it does not create a seam, and prints faster.