Thingiverse
SKR V1.3 WITH 2208 UART Marlin 2.0 Using Stock Ender 3 Screen
by Thingiverse
Last crawled date: 5 years, 9 months ago
I have uploaded Config file for using a SKR v1.3 Board with TMC 2208 UART with stock Ender 3 Screen.
This includes BLtouch (You must check your Bltouch wiring don't assume this will work for every version this was v2 always double-check with a multimeter on servo pins there are so many clones no one can config for them all.) and SD support on Board.
You must Use Exp 1 slot on Board to EXP 3 slot on LCD leave other disconnected.
The Cr10 Stock screen is chosen in Firmware
This file was configured for me and a friend named Alan So change the name before compile or if you choose another LCD screen like rerap smart controller with sd to undefine Cr10 and define Reprap Smart controller.
Just added pick so I could post this.
This includes BLtouch (You must check your Bltouch wiring don't assume this will work for every version this was v2 always double-check with a multimeter on servo pins there are so many clones no one can config for them all.) and SD support on Board.
You must Use Exp 1 slot on Board to EXP 3 slot on LCD leave other disconnected.
The Cr10 Stock screen is chosen in Firmware
This file was configured for me and a friend named Alan So change the name before compile or if you choose another LCD screen like rerap smart controller with sd to undefine Cr10 and define Reprap Smart controller.
Just added pick so I could post this.