Thingiverse
Ski stroller ( Poussette )
by Thingiverse
Last crawled date: 6 years, 5 months ago
** CANADIAN STROLLER *****
PRINT SETTINGS :
PETG
Nozzle : 235 degC
Bed : 80 degC
Infill : 10 % (Could be up to 100 %)
TIP FRONT SKI :
IF the wheels are retained by a pin, try to press and put out the two front wheel.
IF not try to see the user manual (stroller model + .pdf on Google) and see how to desinstall the front swivel wheel.
The front ski has a 0,885'' hole dia. (7/8'' tube stroller).
Make a hole at the level pin or bolt this to the tube. (TIPS ; Heat your your drill bit)
TIP BACK SKI :
My model was a single wheel 1,57'' width that fit straight in the middle.
IF it isn't smaller or you have a double wheel, you can use your imagination to :
strap your double wheel on it ;
or saw one strap holder side if your wheel is bigger (Saw mirror sides would be nice ;))
Be careful on your winter ballad with your baby or 12 cans beer !!!
PRINT SETTINGS :
PETG
Nozzle : 235 degC
Bed : 80 degC
Infill : 10 % (Could be up to 100 %)
TIP FRONT SKI :
IF the wheels are retained by a pin, try to press and put out the two front wheel.
IF not try to see the user manual (stroller model + .pdf on Google) and see how to desinstall the front swivel wheel.
The front ski has a 0,885'' hole dia. (7/8'' tube stroller).
Make a hole at the level pin or bolt this to the tube. (TIPS ; Heat your your drill bit)
TIP BACK SKI :
My model was a single wheel 1,57'' width that fit straight in the middle.
IF it isn't smaller or you have a double wheel, you can use your imagination to :
strap your double wheel on it ;
or saw one strap holder side if your wheel is bigger (Saw mirror sides would be nice ;))
Be careful on your winter ballad with your baby or 12 cans beer !!!