Thingiverse
Ski clip V3 by taeraeyttaejae
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a cross-country ski clip. You need 2 of these.
Please notice - Don't use any hard materials, only print this in flex or semiflex. That is TPU or ninjaflex, or such.
Usage: put front ski sides (curly tip) in first, both skis. Then slide 2nd binding over both skis from rear side. Attach ski poles to small clips so that the handles point to different directions.
You can carry skis using the poles as a handy handle.
Please comment, this is my first thing.
edit 30.12.2017 - made a couple of join operations on the inner clips that broke off because of sloppy modeling.
edit 31.12.2017 - shortened the top shaft to make the ski pole holder tighter, as my poles fell out of old holders.
Please notice - Don't use any hard materials, only print this in flex or semiflex. That is TPU or ninjaflex, or such.
Usage: put front ski sides (curly tip) in first, both skis. Then slide 2nd binding over both skis from rear side. Attach ski poles to small clips so that the handles point to different directions.
You can carry skis using the poles as a handy handle.
Please comment, this is my first thing.
edit 30.12.2017 - made a couple of join operations on the inner clips that broke off because of sloppy modeling.
edit 31.12.2017 - shortened the top shaft to make the ski pole holder tighter, as my poles fell out of old holders.