Ski boots race lifter plate front and back of 5mm thick. by Domi8262

Last crawled date: 3 years ago

Here a set of lifter that is install under alpin race ski boots. They are design to be screw under a ski boots for lifting the boots of 5mm. This is use by racer to get more edge leverage from the boots. I had use Pla for my first print, but Pla is not a good plastic for that, you need a plastic that will be more abrasive resistant and less slippery if possible. May be polycarbonate plastic would be more abrasive resistant, for less slippery I,m not sure what would be the best plastic?? If any body have a suggestion, please let us know. This parts need to be print vertically, if you look at the pictures you will see a small plate-form under the plate this is going on the heat board. When the print is finish just grind that plate-form or cut it.