Simple LED Strip Mount by rshartog

Last crawled date: 3 years, 1 month ago

[UPDATE 8/24/2020] Added V2 which has grooves on the side to retain the LED strip. The LED strip can be pressed directly into the groove, so you don't have to slide it in. V2 must be printed with supports and I have included the STL file for a support enforcer object if you use Slic3r.
The holes for V2 are the same spacing lengthwise as the original version so you should be able to use V2 in the same screw holes in your enclosure. That said, the holes are more centered widthwise in V2, so make sure that works for your application.
[Original Post] This is a very simple mount for attaching LED strips inside the front legs of the Ikea LACK enclosure and aiming them toward the printer. Not hard to design, but it may save someone else a few minutes of design time.
Each one is about 145mm long, so it takes two to mount a 12" LED strip or four if you want a 12" strip on each side.
I printed this in PETG and I'm not sure that the LED mounting tape is going to stick to it well.
[UPDATE 8/23/2020] Added STEP file as requested in comments.