Simple iPad Stand - For Case by dgsharp

Last crawled date: 3 years ago

I really liked the looks of cswaim's "Simple iPad Stand", but lately we have been putting the iPad in a case for my daughter to use it. (We use a Beetle Defense case for our iPad, which I think is a 4th gen iPad, IIRC.) I widened the opening for the iPad by extending the front jaws by 8mm, and it works pretty well.
My printer uses 3mm filament which is basically 1/8", so I just cut off a section of filament and pounded it in with a hammer for the hinge pin. Works great, no glue needed because I didn't clean the hole out so it is pretty tight.
I think it would be nice if it had some tweaks to make the angles mate up with the iPad case better, but it works well as-is, at least for the case we have.