Thingiverse
Simple iMac Stand by Keagan_Exsteen
by Thingiverse
Last crawled date: 4 years, 7 months ago
I've always wanted my own iMac stand but was never up to buying one, so I just printed my own
It feels great having it more elevated as well as blending in well with the desk.
This was printed on my Wanhao Duplicator 4 which I picked up around 2 years ago.
I would suggest at least 35% infill, this particular print is at 15% only and complained a bit when I put down the iMac, on top is a 2012 iMac 21" and has considerable weight.
As it was being printed in the wood filament from eSun, I went with a 0.4mm layer height (nozzle 0.4mm) and a 0.3mm infill layer height.
Printed at 60mm/s
225°C at the nozzle
60°C on the bed
0.4mm Layer height
15% infill - Diamond (fast)
eSun Wood 1.75 PLA Filament
No active cooling Fan
It feels great having it more elevated as well as blending in well with the desk.
This was printed on my Wanhao Duplicator 4 which I picked up around 2 years ago.
I would suggest at least 35% infill, this particular print is at 15% only and complained a bit when I put down the iMac, on top is a 2012 iMac 21" and has considerable weight.
As it was being printed in the wood filament from eSun, I went with a 0.4mm layer height (nozzle 0.4mm) and a 0.3mm infill layer height.
Printed at 60mm/s
225°C at the nozzle
60°C on the bed
0.4mm Layer height
15% infill - Diamond (fast)
eSun Wood 1.75 PLA Filament
No active cooling Fan