Thingiverse
Simple Filament Spool Holder v2 (No supports required) by reddtoric
by Thingiverse
Last crawled date: 3 years, 11 months ago
Print all parts on it's side. Print the (optional) biscuits laid flat on print surface.
No supports needed.
Biscuits are optional. Joining the 2 main parts together are rigid enough to not require biscuits slotted at the bottom of the base.
Print list for a pair of spool holder
2x Female base
2x Male base
4x Bearings
1x Biscuits (Optional & all 3 biscuits should be in the file)
Important!: My prints have tight tolerances, so print with higher quality or it you'll have more post-process work (sanding).
The distance between the shaft (surface that is outer most of the female part) and the bearing is 0.3mm. Which gives enough room to not be a loose bearing but still enough to spin freely.
The distance between the female and male parts is 0.8mm and should fit snug but not hard to pull apart.
The rounded half circle on either male or female parts should not warp at least not warping inwards causing friction with the bearing. The 90 degree corners at the base can be warped a little; it won't affect the function.
The side to side clearance between the bearing and a main part is 0.4mm. 0.2mm each side if centered.
Print with 0.2mm layer quality because it's designed with that in mind so there are no non-full height layers where it might be affect the function
No supports needed.
Biscuits are optional. Joining the 2 main parts together are rigid enough to not require biscuits slotted at the bottom of the base.
Print list for a pair of spool holder
2x Female base
2x Male base
4x Bearings
1x Biscuits (Optional & all 3 biscuits should be in the file)
Important!: My prints have tight tolerances, so print with higher quality or it you'll have more post-process work (sanding).
The distance between the shaft (surface that is outer most of the female part) and the bearing is 0.3mm. Which gives enough room to not be a loose bearing but still enough to spin freely.
The distance between the female and male parts is 0.8mm and should fit snug but not hard to pull apart.
The rounded half circle on either male or female parts should not warp at least not warping inwards causing friction with the bearing. The 90 degree corners at the base can be warped a little; it won't affect the function.
The side to side clearance between the bearing and a main part is 0.4mm. 0.2mm each side if centered.
Print with 0.2mm layer quality because it's designed with that in mind so there are no non-full height layers where it might be affect the function