SIG/GSG 1911 +3 Magazine Follower by Infinitus

Last crawled date: 3 years, 2 months ago

Replacement follower for stock gsg/sig 1911 single stack magazines. Adds +3 capacity for a total of 13.
Installation Instructions:
Push original follower to the bottom of the magazine.
Push horizontal pin out through hole in the bottom of the examination window.
Push small screwdriver through hole on the base of the magazine, while depressing the internal pin, slide base off forwards (watch out that the spring doesn't jump out).
Remove original spring, follower and pin. Replace follower with 3d printed one, then reconstruct.
Horizontal pin should not be put back in (the 3d print does not even contain a hole for it), this is required as the new follower needs to move along a further range would be possible with the pin in-place.