Thingiverse
Shock Mount for Zoom H1/H1n by dout3
by Thingiverse
Last crawled date: 4 years, 6 months ago
The goal was to make a low profile shock mount and use as few non-printable parts as possible. I also wanted the device to still be easy to use.
What do you need:
-Tripod Screw
-Glue
-Rubber bands or hair loops
-Electrical tape
-This model https://www.thingiverse.com/thing:2897509
-"Shock Mount Plate"
-"Shock Mount Base"
1.Print all the parts and remove brims/supports
2.Glue GoPro mount to the base and allow the glue to dry
3.Cut off the excess
4.Add two small electrical tape pieces to the plate and add the tripod screw
5.Add the rubber bands and if they are too loose, add a knot to them.
Bravo!
What do you need:
-Tripod Screw
-Glue
-Rubber bands or hair loops
-Electrical tape
-This model https://www.thingiverse.com/thing:2897509
-"Shock Mount Plate"
-"Shock Mount Base"
1.Print all the parts and remove brims/supports
2.Glue GoPro mount to the base and allow the glue to dry
3.Cut off the excess
4.Add two small electrical tape pieces to the plate and add the tripod screw
5.Add the rubber bands and if they are too loose, add a knot to them.
Bravo!