Thingiverse
Shendrones Mitsuko Skirt by methree
by Thingiverse
Last crawled date: 4 years, 5 months ago
Shown on mine is a 2 piece design. The one I uploaded is a 1-piece design. The FC access notch was designed for an FC with a center USB.
Disclaimer.
1) This was designed for my Shendrones Mitsuko 5. The production Shendrones model is a Mitsuko 4.
2) My XYZ Davinci 1.0A tends to make holes smaller and closer in ABS than I model them in Solidworks, so I modeled these files to compensate. The fit is near perfect on my Mitsuko. your results may vary. For this reason, I have uploaded "Mitsuko Tester.stl" Download and print this part first. Its just a 1.5mm thick template so that you can test the fit. If it slides over your standoffs well, then the real skirt will fit too. The tester is for test only. Dispose of it.
Disclaimer.
1) This was designed for my Shendrones Mitsuko 5. The production Shendrones model is a Mitsuko 4.
2) My XYZ Davinci 1.0A tends to make holes smaller and closer in ABS than I model them in Solidworks, so I modeled these files to compensate. The fit is near perfect on my Mitsuko. your results may vary. For this reason, I have uploaded "Mitsuko Tester.stl" Download and print this part first. Its just a 1.5mm thick template so that you can test the fit. If it slides over your standoffs well, then the real skirt will fit too. The tester is for test only. Dispose of it.