Shelf Riser

... to place a laptop and dock so it is out of the way. board used as a shelf was an ikea chopping board ~20in x ~11in x ~1in thick.

...thingiverse simple shelf or riser if you need extra cooling underneath or simple need to mount something else on to of your vtx.

...d and desired about of risers to support it. i used super glue to hold the board to them. part measures 9.25x3.5x1 inches (lxhxw)

...t is, but it should work to multiple models with the same messurements (17-18mm rail with 40mm from wall to center rail, or more)

...viewing when power supply is on desktop rather than an eye-level shelf. wide base for stability. sketchup design file included.

...kly make some desk risers or footrests then here you go. also include f3d files for you guys to adjust both height and tolerance.

...or print settings: layer height: 0.28 - or more doesn't matter infill: 20% supports: no filament: any i hope u will enjoy it.

...thingiverse parts: x1 ikea algot shelf 15 7/8 x 7 1/8 inch x2 printed riser no screw or glue needed https://youtu.be/-nk_3gnh0su

... shelf board to assemble the monitor riser. print 30% infill with 2 perimeters at least. takes about 6 hours and $2 of filament.

...ing using the "open in customizer" button. the three styles are designed to balance filament use with ease of printing.

...riser by raduka thingiverse riser

...riser pcie thingiverse riser pcie lock

...pot riser thingiverse small risers to set your planters on to let the water drain

...monitor riser thingiverse monitor riser for a 6.5 inch x 8 inch rectangle base monitor.

...se variance for the riser functions that have pegs or holes, you can adjust the following: -peg/hole size -peg height -hole depth

...stock riser by thetaxman23 thingiverse stock riser

...picatinny riser by cairoringo thingiverse simple riser

...degree riser by mbremer thingiverse 4º riser pad

...monitor riser by adamdthornton thingiverse computer monitor riser that is modular

...router shelf. just a shelf ))) by kormag thingiverse router, wifi, shelf

... 10 assuming tensile yield at 50mpa. the bracket requires 2x m4 countersunk (ctsk flat - din en iso 7046-1) screws for mounting

...f thingiverse this is a shelf and key organizer. width: 80mm length: 60mm. link to my website: https://quinten3d.simplesite.com/

...shelf by bcsprayer thingiverse shelf

...shelf by costa_d thingiverse shelf

...shelf by maxfm thingiverse a shelf

...shelf by 3dform thingiverse shelf

...shelf by doesliverpool thingiverse shelf

...shelf by themaker132 thingiverse a shelf