Thingiverse
Shelf End Cap and mount by skelo
by Thingiverse
Last crawled date: 4 years, 2 months ago
ClosetMaid specific, but I guess could be reworked for top to bottom rail spacing.
I print a mirrored set so that I can use the bottom side (first layer) which is a the better finish in my opinion to show better for install.
You may have to make them a little thicker based on the space between the end of the shelf wall. I had some that were cut 1/2" short of the wall.
I print a mirrored set so that I can use the bottom side (first layer) which is a the better finish in my opinion to show better for install.
You may have to make them a little thicker based on the space between the end of the shelf wall. I had some that were cut 1/2" short of the wall.