Thingiverse
servo winch replacement bottom by wouterb
by Thingiverse
Last crawled date: 4 years, 1 month ago
Bottom replaces the standard servo underside. This one is based on a TowerPro MG995.
Servo needs additional work to make a winch.
additional parts needed:
5mm shaft (ie. stainless steel)
Drum to hold the winch line.
bearing 11x5x4mm
additional work:
remove potmeter and contol print.
make an opening in the side of the servo
extended workplan on request.
Different donor Servos might need different approaches
Servo needs additional work to make a winch.
additional parts needed:
5mm shaft (ie. stainless steel)
Drum to hold the winch line.
bearing 11x5x4mm
additional work:
remove potmeter and contol print.
make an opening in the side of the servo
extended workplan on request.
Different donor Servos might need different approaches