Thingiverse
SeeMeCNC Eris Berd-Air Part Cooling Upgrade Pack by themitch22
by Thingiverse
Last crawled date: 4 years, 3 months ago
The stock Eris doesn't have very good part cooling, causing wobbly sidewalls, messy overhangs, and oozing. There's a single 30mm blower fan due to the tiny effector, so this upgrade pack improves hotend and print cooling for the SeeMeCNC Eris.
Berd-Air V2 Cooling Kit 12V:http://www.themakerhive.com/shop/viewitem.php?productid=45
The fan shroud is designed for a 30mmx10mm radial fan, I'm using the E3D fan from my prusa mk2.
The tube holder uses a M3x8mm screw to tighten and the 3mm screws from the Eris effector. Bend the tube carefully using a 22AWG wire inserted to prevent kinking.
The 30mm fan shroud has to be placed in the angle as shown in the picture to clear the arms and the whip connector, it's a very tight fit!
Fan 0 on the Rambo Mini works as a part cooling fan, it's tied to the whip but the HE280 PCB the fan connector isn't used. I'm using the e-switch kit to control the pump speed from the main Eris power supply 12V: http://www.themakerhive.com/shop/viewitem.php?productid=41
Berd-Air V2 Cooling Kit 12V:http://www.themakerhive.com/shop/viewitem.php?productid=45
The fan shroud is designed for a 30mmx10mm radial fan, I'm using the E3D fan from my prusa mk2.
The tube holder uses a M3x8mm screw to tighten and the 3mm screws from the Eris effector. Bend the tube carefully using a 22AWG wire inserted to prevent kinking.
The 30mm fan shroud has to be placed in the angle as shown in the picture to clear the arms and the whip connector, it's a very tight fit!
Fan 0 on the Rambo Mini works as a part cooling fan, it's tied to the whip but the HE280 PCB the fan connector isn't used. I'm using the e-switch kit to control the pump speed from the main Eris power supply 12V: http://www.themakerhive.com/shop/viewitem.php?productid=41