Sea Port Benchy - 3DBenchy Stand by jmckerna

Last crawled date: 3 years, 4 months ago

This is a modular stand for your 3DBenchy test prints.
The stand can be expanded horizontally and/or vertically using the "mending plates" and M3 screws (I used M3 hex socket button head cap screws). Typically I used M3x12mm or M3x14mm for the screws that go into the base plates and no longer than M3x8mm screws that go into the top of the backs to connect the next level above. There are also small clips that can be used to keep the base plates straight and not separate at the front. The clips come in large and small sizes although printing in PLA the small size typically works best. The large is provided for a slightly tighter fit.
The "tray" pieces are mirrored so they will seamlessly go side to side looking like continuous water surface if you alternate between tray A and tray B.
There are additional test print stands available.
If you print a Filament Friday CHEP cube or any 20mm calibration cubehttps://www.thingiverse.com/thing:4603385
If you print MatterHackers Phil A Ment at 50% of the original sizehttps://www.thingiverse.com/thing:4606581
If you print a VORON Design calibration cubehttps://www.thingiverse.com/thing:4693719