SD-Card storage (25 cards) by olidub

Last crawled date: 3 years ago

Some say, 12 cards are not enough.
Thats the reason why i've created a new SD-Rotor for 25 cards. It works like my first version:https://www.thingiverse.com/thing:2803750
The 12 and 25 card holder are stackable with some rubber bumpers.
New: rotor and stator are aligned for printing (no need to turn upside down)
The stator has an integrated support for the center hole. After printing, bend off the support with a screwdriver and slide it out from below (for example with a screw through the screw hole). There is a gap between support and body of 0.2 mm which is a breaking point for the support.
You need a screw M6x30 an M6 washer and an M6 locknut.
The pointer is to show you where the lifting cam stays.
Choose the right part after tightening the screw.
Use the " pointer " when the lifting cam comes to rest on the edge of the nut.
Use the "pointer flat" when the lifting cam comes to rest on the surface of the nut.
Added: 2 new designed pointers. Better to print.
Plug the pointer on the hex nut.
I hope someone understands this. ;-)