Satsana Fan Grill / Cover / Protector by fish22

Last crawled date: 2 years, 11 months ago

Cover and protect your fan installed in this awesome Satsana fan duct.
Friction fit fan cover (no extra screws needed!) designed to protect the hot end fan for the Satsana fan duct for Ender 3. It took me a couple of iterations to eliminate amplified fan noise when grills are too close to the fan.
You may have to adjust X scale by a bit to allow tolerance depending on how well calibrated your printer is. Or you can heat (with a match, lighter or soldering iron, etc...) the side walls and pinch it a little while the plastic is still flexible.
Printing time took me about 1 hour and 15 minutes with Cura settings below.
Printing:
Printed without support.
Tried and tested on PLA.
Layer height - 0.2mm
Infill - 10%
Wall - 0.4, 2 layers
Print speed - 50mm/s