Thingiverse
Sagrotan / Dettol Plug for Refill by benzol
by Thingiverse
Last crawled date: 4 years, 7 months ago
Thisis a remix from a simple plug. However I found it difficult to remove. So I just added to the model from jojoslf a small handle.
It prints fine with supports.
Instructions:
Drill a hole in the top center of the bottle (cone drill works well).
As jojoslf pointed out with the original design, you need to clean out the drilling debris.
The original bottle will contain some remaining soap. You can wash the bottle repeatingly with small amounts of water.
For the final cleanout I used a syringte to get the remaining water out.
Direct refill with liquid soap worked for me as the remaining water content is so small.
Have fun
It prints fine with supports.
Instructions:
Drill a hole in the top center of the bottle (cone drill works well).
As jojoslf pointed out with the original design, you need to clean out the drilling debris.
The original bottle will contain some remaining soap. You can wash the bottle repeatingly with small amounts of water.
For the final cleanout I used a syringte to get the remaining water out.
Direct refill with liquid soap worked for me as the remaining water content is so small.
Have fun