Thingiverse
Runcam Split camera holder for QAV 180 / 210 by techyg
by Thingiverse
Last crawled date: 4 years, 5 months ago
This camera holder is for the Runcam Split camera (may also work with other cameras of the same profile), and should work for both a QAV 180 and 210 frame. The mounting hardware that came with the Runcam Split didn't work very well, so I designed this one. This design brings the camera forward a little bit. This is intended to be printed with a semi-flex filament. I used Sainsmart TPU and it works great. Anything softer (eg NinjaFlex) will probably not support the camera as well, and anything harder (eg PLA) may cause too much jello.
When using your camera with the holder, you will still see some of the standoffs in the video if you fly at a steep angle. I am thinking about doing another version that moves the camera out past the standoffs so this will no longer be a problem (down side is the lens won't be protected).
You'll need to use one of the small included screws (that comes the Runcam Split) in the bottom holes of the camera.
Sample video footage here:https://www.youtube.com/watch?v=0MF9jcGSdZQ
When using your camera with the holder, you will still see some of the standoffs in the video if you fly at a steep angle. I am thinking about doing another version that moves the camera out past the standoffs so this will no longer be a problem (down side is the lens won't be protected).
You'll need to use one of the small included screws (that comes the Runcam Split) in the bottom holes of the camera.
Sample video footage here:https://www.youtube.com/watch?v=0MF9jcGSdZQ