Ruger mkIII 22/45 Lite gas pedal by hulabaloo

Last crawled date: 4 years, 3 months ago

USE AT YOUR OWN RISK
NON-COMMERCIAL license! If it shows up on etsy or ebay etc, I will ask for it to be taken down. This should be cheap to make or have a friend make. I don't want to see someone selling this for $20.
You will need to replace the trigger pin with a spare ar15 anti-rotation pin that is threaded on both ends.
1 side needs to stick out - left or right whichever is opposite of the hand you mainly shoot with. IF the plastic breaks the pin is captured with screws on both ends so it should not fall out though it will stick out and possibly move side to side.
I printed in PETG for heat resistance but PLA was strong too. You can make any combo of colors you like.
Steps to install
1) clear pistol and make safe
2) remove bolt and separate the frame from the barrel
3) find video on youtube on how to partially push the trigger pin out. need to push down on the retaining spring. Push from right to left side (right handed shooter). Only push partially out.
4) add 1 screw to anti-walk/anti-rotation pin. you can use loc tite but remember loc tite eats plastic. push from right to left pushing original pin out. Push til screw is flush against the frame
5) holding the anti walk pin from right side, add the printed gas pedal
6) insert screw from left side and screw both sides in til firm.
0.15-0.2 layer height
100% infill
no supports
no raft
no brim.