Thingiverse
Rubik's Cube Stand (General Cube Stand) by TorayIntern
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is a stand that is only 1.125in tall and has 4in sides as the base. Concave at the top to a 20 degree draft angle to allow the cube to center on the stand.
Fits large sizes to a point as long as the center of mass of the object is relatively close to it's geographical center.
For a general stand there is also a 0.5in tall and 3.25in side stand. Concave at the top with chamfered edges and a 45 degree draft. The thickness is also reduced for fast printing
RubiK's Stand is the general fit Stand (45 degrees 3in wide)
PCG Stand has the 20 degree sharp angle
Fits large sizes to a point as long as the center of mass of the object is relatively close to it's geographical center.
For a general stand there is also a 0.5in tall and 3.25in side stand. Concave at the top with chamfered edges and a 45 degree draft. The thickness is also reduced for fast printing
RubiK's Stand is the general fit Stand (45 degrees 3in wide)
PCG Stand has the 20 degree sharp angle