Router Fence for Table Saw by constabilecustom 3d model
3dmdb logo
Thingiverse
Router Fence for Table Saw by constabilecustom

Router Fence for Table Saw by constabilecustom

by Thingiverse
Last crawled date: 3 years, 3 months ago
A 4 piece router fence with built in dust port designed so that I can use my table saw (Delta 36-725) fence for the router mounted on the wing. The print does slide on the fence, so I use 2 spring clamps to hold it in place, but I am sure there are better methods of holding it.
Print 2 end sections and a 1 of each mid section, then glue together.
I printed these with additional exterior perimeters to give it a bit more strength, and supports are needed for the mid sections, at least from the build plate only, but not totally necessary for the ends if you print it in the proper orientation.
Please leave any feedback, and if you like the design leave a like!

Tags