Thingiverse
Roomba 960 bearing and shaft by jameslee522
by Thingiverse
Last crawled date: 4 years, 11 months ago
Roomba 960 parts I modeled in Fusion360 real quick and printed.
I used PETG. The shaft was printed with supports, the bushing body was not.
You need the brass bushing from and old part. Heat it up over the stove and press in.
Same with the shaft.
I used PETG. The shaft was printed with supports, the bushing body was not.
You need the brass bushing from and old part. Heat it up over the stove and press in.
Same with the shaft.