Thingiverse
RoBo3D Y Axis Remix by mkelly
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is a remix of the stock RoBo3D Y axis. It can be used as replacement parts for the Robo3D Y axis as well
BOM:
Printed:
2x Y Axis End Brackets
2x Belt Tensioner
4x Pillow Block
Hardware:
4x LM8UU linear bearings
8-12x M3-40mm length screws
8-12x M3 lock nuts
2x M4 Nut
2x M4-10mm Screw
8x 3/8" (10mm) x 1/8" (3mm) neodymium magnets
2x 8mm Smooth Rod - 378mm Length (14.875)
CA glue or two part epoxy is good for gluing the magnets to the bed/plastic. I used 2 part plastic epoxy
Suggested material is ABS due to bed heat. Print at 50% or greater for best results.
BOM:
Printed:
2x Y Axis End Brackets
2x Belt Tensioner
4x Pillow Block
Hardware:
4x LM8UU linear bearings
8-12x M3-40mm length screws
8-12x M3 lock nuts
2x M4 Nut
2x M4-10mm Screw
8x 3/8" (10mm) x 1/8" (3mm) neodymium magnets
2x 8mm Smooth Rod - 378mm Length (14.875)
CA glue or two part epoxy is good for gluing the magnets to the bed/plastic. I used 2 part plastic epoxy
Suggested material is ABS due to bed heat. Print at 50% or greater for best results.