Robo3d Full Graphic Smart LCD Mount by kengeer

Last crawled date: 4 years ago

This is a fixed lcd mount that fits the Sintron 12864 full graphic smart controller case. I can't quite remember which case I printed, but should fit this one http://www.thingiverse.com/thing:87250. It fits snug on my older R1 from 2014 that does not have the bottom cover. You will need to buy a new mounting bolt M6-1.00 x 20, the original one was too short on mine. I cut a hole on the inside of the printer case and another little slit to the outside between the top and bottom (see picture) and I fed the cable through the holes to the outside. You will also need two 2.8mm screws that are at least 7mm long.