Thingiverse
Robo3D Adjustable Z stabilizers by PD5DJ
by Thingiverse
Last crawled date: 4 years, 1 month ago
When I was modding my Robo3D printer, I came across some Z stabilizer designs..
All of the designs are fixed measurements.
This questioned me, because not any Robo3D casing has the same distance to the Z axis support rods, there is always some tolerance in measurement.
This can give some strain on the X/Z axis rods.
Therefore I designed a set of adjustable ones.
You will need the following hardware:
4x M4 bolt +/- 15mm
4x M4 nut
6x M4 ring
All of the designs are fixed measurements.
This questioned me, because not any Robo3D casing has the same distance to the Z axis support rods, there is always some tolerance in measurement.
This can give some strain on the X/Z axis rods.
Therefore I designed a set of adjustable ones.
You will need the following hardware:
4x M4 bolt +/- 15mm
4x M4 nut
6x M4 ring