Thingiverse
RL 2020 filament guide by notrslau
by Thingiverse
Last crawled date: 5 years, 3 months ago
I had trouble printing the original design - the "cut" part of the loops would separate from the bed. Plus, PETG does not like small parts.
I am using this on an Ender 5 Plus with a direct drive modification (https://www.thingiverse.com/thing:4041743). It has a large bed so the filament needs to move a lot. I used a stretched torus as the guide to accommodate that movement.
Unfortunately, I could not think of a way to model this so it would print flat without supports. It prints in two or three pieces that you will need to glue together, which is very easy. There are two versions - one with a slot for a bottom guide and one without. Pick the one that works better for your filament path.
I am using this on an Ender 5 Plus with a direct drive modification (https://www.thingiverse.com/thing:4041743). It has a large bed so the filament needs to move a lot. I used a stretched torus as the guide to accommodate that movement.
Unfortunately, I could not think of a way to model this so it would print flat without supports. It prints in two or three pieces that you will need to glue together, which is very easy. There are two versions - one with a slot for a bottom guide and one without. Pick the one that works better for your filament path.