rivit by jesse53

...1/4 inch air hose clip by jeffwaz thingiverse holds air hose to reel, use pop rivits in the holes to attach

... petg support touching buildplate ony for the flat rivit counter sinks,no supports for the tube. also included a few other styles

...rley visible on a sla,so while they look good on the screen i am having second thoughts about adding this kind of detail anymore.

...vided "rivits" to hold on the straps if anyone feels industrious enough to glue straps to the opposite side for effect.

...d to scale down. (take care in wall thickness, the helmet is modeld after a real one and steel thickness is as it was originally)

... feel free to add these files into your project/modify as you see fit. you own it, i just wanted to make it simpler for people :)

...r midrange speaker above air duct by use of butyl plates -close gaps arround adapter to create sealed volume for midrange speaker

... and came back down and the video was rock solid. so far it's working well. i will update with a more extensive range test.

... of 6,5 or 7mm (they are intensionally sligthly to small in the model) -install the speaker, rember to form a ellbow in the cable

...base by jesse53 thingiverse base

...bezil by jesse53 thingiverse car part

...ornament by jesse53 thingiverse did it in vectary

...jeffwaz thingiverse holds air hose to reel, use pop rivit in the holes to...

...from petg support touching buildplate ony for the flat rivit counter sinks,no supports for the tube. also included a...

...either fdm or sla there are realy realy small rivit that i would normally not put on any of...

...raised lettering on the shield itself. i have provided "rivit" to hold on the straps if anyone feels industrious...

...1 world war 2 brodie helmet with the 2 rivit and point weld on the rim protector, so this...

...the original, and started using tie wire as my "rivit", since it is super cheap to get in bulk,...

...to cut off sligthly (see pictures) -use 3 plastic rivit for fixation -form a proper volume for midrange speaker...

...center. next take the back plane backer, put the rivit through it. then put the copper board on it...

...tightening the screws until it touches the plastic threaded rivit which was also used for the oem speaker -us...