Thingiverse
Ring2: Corner Mount Bracket by DocDrill
by Thingiverse
Last crawled date: 4 years, 10 months ago
My front porch didn't have a good location for a flush mount. Although Ring apparently has some options for a 15degree mount, I neither had it nor thought that angle would be sufficient. This is a true 45degree mount.
Designed to print without supports.
Hardware - (OPTIONAL - See Below):
(4) M3x12mm Hex Head
(4) M3 Nuts
Amazon Affiliate Link: https://amzn.to/2UOkQ8v
I think anyone printing should have a kit like this kit.
IF YOU WANT TO SKIP THE HARDWARE, I'm including a design (SelfThread) that will HOPEFULLY allow you to use the included Hex bolts to thread into the print. It's not a threaded design, but the print should be threadable. I HAVE NOT test printed this. Let me know if it's wrong, and I can update. Truth is, depending on how well tuned your printer is, the hole is likely to be a tough tighter. The thread diameter is 2.9 and I designed at 2.7, knowing it'll likely be a bit tighter.
Designed to print without supports.
Hardware - (OPTIONAL - See Below):
(4) M3x12mm Hex Head
(4) M3 Nuts
Amazon Affiliate Link: https://amzn.to/2UOkQ8v
I think anyone printing should have a kit like this kit.
IF YOU WANT TO SKIP THE HARDWARE, I'm including a design (SelfThread) that will HOPEFULLY allow you to use the included Hex bolts to thread into the print. It's not a threaded design, but the print should be threadable. I HAVE NOT test printed this. Let me know if it's wrong, and I can update. Truth is, depending on how well tuned your printer is, the hole is likely to be a tough tighter. The thread diameter is 2.9 and I designed at 2.7, knowing it'll likely be a bit tighter.