Ring Doorbell Pro Offset

Last crawled date: 5 years, 7 months ago

This is a simple offset for the Ring Doorbell Pro. Nothing fancy, just a box that creates a spacer for the doorbell. I tested it in PLA, but ABS would be best for outdoor use. Print it flat on its back and you won't need supports for the screw holes. There's hole in the back for two screws and a hole to bring the wires through. My wires were long enough to barely reach, but you may need to extend yours. There is a slight gap once installed due to the fins on the back of the Ring itself, but this could easily be filled with caulk or foam.