Thingiverse
Reverse Plunger for Nerf Longstrike by Heffkip
by Thingiverse
Last crawled date: 4 years, 2 months ago
Reverse plunger component from a nerf longstrike, slightly modified from original to be a bit easier to print (internal featured an overhang which I've replaced with a 45° incline).
Dimensions were taken from original part using micrometer. Model was constructed in solidworks.
Update:
Part was printed in ABS filament in horizontal orientation. This gave a slight elliptical deformation but otherwise the part came out fine.
When attaching to the existing internals the head split slightly when attaching to the air-restrictor. This was likely due to shrinkage so I either suggest printing the part marginally larger or sanding down the joint to fit flush before gluing.
Once installed the part performed fine and gun fired as normal.
Dimensions were taken from original part using micrometer. Model was constructed in solidworks.
Update:
Part was printed in ABS filament in horizontal orientation. This gave a slight elliptical deformation but otherwise the part came out fine.
When attaching to the existing internals the head split slightly when attaching to the air-restrictor. This was likely due to shrinkage so I either suggest printing the part marginally larger or sanding down the joint to fit flush before gluing.
Once installed the part performed fine and gun fired as normal.