Thingiverse
Revell/Zvezda 1:2700 Star Destroyer replacement garbage chute by martaaay
by Thingiverse
Last crawled date: 5 years, 8 months ago
This is a garbage chute for the back of the Revell/Zvezda 1:2700 Star Destroyer that doesn't have a garbage chute. It's based on reference photos of the Star Destroyer used in Empire Strikes Back that the Millenium Falcon sits on to hide from the empire.
You'll need to cut open a rectangular hole about 15mm x 6.6mm and slide the piece in. Remember to sand at a fairly steep angle because the chute is parallel to the floor, not the angle of the back of the Star Destroyer, which is at about a 57 degree angle. There are some great videos on Youtube of other people doing this step for other after market versions of the garbage chute.
For bigger models, this would probably scale ok as I have more detail than my Photon S SLA printer can print.
Included is the raw stl and a version with supports that worked well.
If the model imports into Prusaslicer super small, set the scale to 2540%. The dimensions should be 17.78mm x 17.03mm x 8.44mm.
You'll need to cut open a rectangular hole about 15mm x 6.6mm and slide the piece in. Remember to sand at a fairly steep angle because the chute is parallel to the floor, not the angle of the back of the Star Destroyer, which is at about a 57 degree angle. There are some great videos on Youtube of other people doing this step for other after market versions of the garbage chute.
For bigger models, this would probably scale ok as I have more detail than my Photon S SLA printer can print.
Included is the raw stl and a version with supports that worked well.
If the model imports into Prusaslicer super small, set the scale to 2540%. The dimensions should be 17.78mm x 17.03mm x 8.44mm.