Thingiverse
Replicator Cover Hanger Bolt Spacers v2 by Fastrack
by Thingiverse
Last crawled date: 4 years, 11 months ago
A pair of spacers for drandolph's "3mm hood and cover" thingiverse.com/thing:23386
These pieces keep compression on both bolts holding the y-axis rods when hanging the front cover.
I found the original were too close together and printed as one piece (probably my HBP to nozzle height). They also weren't high enough. I enlarged the center hole by .35mm as well.
Inside diameter - 3.35mm
Outside diameter - 4.35mm
Height - 5.5mm
"Washer" - 8mm x .75mm
The height allows for about 1mm or so of movement on the front hood, making removing/adding it a breeze.
In my quest to eliminate the vibration sounds. I've added a shorter spacer set with a height of 4.5mm. The cover fits nice and snug and in combination with the lift handles & stabilizer brackets the vibration sounds are gone!
For the lift handles & stabilizer brackets please see thingiverse.com/thing:27532
These pieces keep compression on both bolts holding the y-axis rods when hanging the front cover.
I found the original were too close together and printed as one piece (probably my HBP to nozzle height). They also weren't high enough. I enlarged the center hole by .35mm as well.
Inside diameter - 3.35mm
Outside diameter - 4.35mm
Height - 5.5mm
"Washer" - 8mm x .75mm
The height allows for about 1mm or so of movement on the front hood, making removing/adding it a breeze.
In my quest to eliminate the vibration sounds. I've added a shorter spacer set with a height of 4.5mm. The cover fits nice and snug and in combination with the lift handles & stabilizer brackets the vibration sounds are gone!
For the lift handles & stabilizer brackets please see thingiverse.com/thing:27532