Thingiverse
Replicator 2x Hood Gap Filler by tempo502
by Thingiverse
Last crawled date: 4 years, 7 months ago
I made this to close the gap in the R2x enclosure hood where the feed tubes and wiring pass through. It has tabs that slide into a gap in the rear enclosure panel -- no fasteners required!
I'm using it with fume filter http://www.thingiverse.com/thing:125264 and corner hole-fillers http://www.thingiverse.com/thing:151513 by RodLaird. The ABS smell is almost entirely gone, and the build chamber stays a bit warmer (45-50C).
I have attached a version with a flexible bellows section, and a flat version. I use the bellows version to give the feed tubes more play, but it may be difficult to print at lower resolutions.
I'm using it with fume filter http://www.thingiverse.com/thing:125264 and corner hole-fillers http://www.thingiverse.com/thing:151513 by RodLaird. The ABS smell is almost entirely gone, and the build chamber stays a bit warmer (45-50C).
I have attached a version with a flexible bellows section, and a flat version. I use the bellows version to give the feed tubes more play, but it may be difficult to print at lower resolutions.