Repetier auto-level 0.92.9 for DMY3DP-001 (p802m / anet a8 clone) by crazytiti

Last crawled date: 3 years, 1 month ago

All files are on github :https://github.com/crazytiti/Repetier0.92.9-DMY3DP
This is preconfigurated repetier firmware 0.92.9 with auto level for DMY3DP-001 3d printer (anet a8 clone with modified melzi electronics)
It use the bed sensor to auto level and correct distortion.
Be aware on first use !
You must check if the head will scratch the bed.
To adjust the first layer height you must adjust Z_Probe_height in eeprom settings accordingly to your printer.
Use repetier host to adjust eeprom settings.
The starting G-code must contain :
G28 ; home X and Y (Z homing disabled in firmware)
G1 X10 Y10 Z10; going out of parking pos
G32 ; auto bed level Repetier
To compile it you need to add the sanguino board to arduino :
Add this board manager to your arduino :https://raw.githubusercontent.com/Lauszus/Sanguino/master/package_lauszus_sanguino_index.json
See full explanation on https://github.com/Lauszus/Sanguino
To upload it you may need and ISP to put the arduino bootloader on your board, then use classic arduino USB upload.
Demo :https://youtu.be/xS7Vn1HkF7k