Thingiverse
REMIX-Pwncnc-V5-Boot by kaoskido
by Thingiverse
Last crawled date: 4 years, 11 months ago
REMIX-Pwncnc-V5-Boot
-Remixed to have lip on bush plate (attempt to avoid lateral movement)
-Remixed to use these magnets:https://www.amazon.com/gp/product/B07C6CYPLR/
-Remixed brush plate to have deeper channel for brush
Printed on Anet ET4 - Hatchbox PLA - .28 Layer Height
01-02-2021 Update---
Works and I had no lateral movement. I did find that the brush track does not accept easily the McMaster Carr brush strips.
Running with a 3" brush and the bristles do go into the end mill chopping them off.
If your going to run only a 3" brush then this is not the ideal dust shoe IMO.
-Remixed to have lip on bush plate (attempt to avoid lateral movement)
-Remixed to use these magnets:https://www.amazon.com/gp/product/B07C6CYPLR/
-Remixed brush plate to have deeper channel for brush
Printed on Anet ET4 - Hatchbox PLA - .28 Layer Height
01-02-2021 Update---
Works and I had no lateral movement. I did find that the brush track does not accept easily the McMaster Carr brush strips.
Running with a 3" brush and the bristles do go into the end mill chopping them off.
If your going to run only a 3" brush then this is not the ideal dust shoe IMO.