Thingiverse
Remix of Modular Hydroponic System by seBASTARD
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a Remix of the Modular Hydroponic System by archipelagourbanfarms.
The vase lid for the Ikea vase was to big to be printed on my Anet A8, therefore I had to split it into 4 Parts and add some parts to connect it after Print. M3 x 20 screws + nuts are used for this.
Since I wanted a desk version that does not have any unnecessary cables or tubing on the outside, I drilled a hole for the power cable of the pump directly at the joining vase lid parts. Drill the hole, unscrew, place cable and screw bac together.
I also changed the placement of the water tube. It will go inside the system and through the overflow protection of the top reservoir. I designed a small water distribution for the top reservoir tha fits on a 6mm tube.
The vase lid for the Ikea vase was to big to be printed on my Anet A8, therefore I had to split it into 4 Parts and add some parts to connect it after Print. M3 x 20 screws + nuts are used for this.
Since I wanted a desk version that does not have any unnecessary cables or tubing on the outside, I drilled a hole for the power cable of the pump directly at the joining vase lid parts. Drill the hole, unscrew, place cable and screw bac together.
I also changed the placement of the water tube. It will go inside the system and through the overflow protection of the top reservoir. I designed a small water distribution for the top reservoir tha fits on a 6mm tube.