Thingiverse
(Remix) Low Poly Canopy RCExplorer V4 by ImmortalScientist
by Thingiverse
Last crawled date: 4 years, 2 months ago
This is a remix/redesign of Temp1337's Low Poly Canopy - I had to remodel the file from the STL of the other design, so there are some small differences in geometry aside from the wire holes and antenna tube guides. I have also made the shell thicker - at the expense of a bit more weight, this variant has much sturdier walls - Should take an impact or two better than the original design.
The zip-tie holes from this remix's predecessor have been removed, so the canopy should be mounted using the bolt holes (use nylon locknuts to avoid vibration-induced loosening).
3mm antenna shielding tube should be inserted into the tube guides and optionally glued into place to support wire-type antennas.
Modelled in Fusion 360.
The zip-tie holes from this remix's predecessor have been removed, so the canopy should be mounted using the bolt holes (use nylon locknuts to avoid vibration-induced loosening).
3mm antenna shielding tube should be inserted into the tube guides and optionally glued into place to support wire-type antennas.
Modelled in Fusion 360.