Thingiverse
Rear Cupholder for Porsche 991 911 by osunick
by Thingiverse
Last crawled date: 4 years, 6 months ago
This fits in the bin between the rear seats and is secured by the nut that secures the lower seat squab to the car. To install:
Remove rubber mat on bottom of rear bin
Under this mat, there is a plastic door, remove it.
Remove nut under door.
Print cupholder
Insert cupholder and secure with nut
Cover nut with cap
Cup holder is at 4 degree angle so that the holder sits level with the ground. Diameter of the cupholder is 80mm, large enough for standard Hydro Flask w/rubber bottoms but not the wide models. Optional spring insert for narrower diameter cups.
Cupholder liner is optional and should be printed in TPU or some other flex material.
Remove rubber mat on bottom of rear bin
Under this mat, there is a plastic door, remove it.
Remove nut under door.
Print cupholder
Insert cupholder and secure with nut
Cover nut with cap
Cup holder is at 4 degree angle so that the holder sits level with the ground. Diameter of the cupholder is 80mm, large enough for standard Hydro Flask w/rubber bottoms but not the wide models. Optional spring insert for narrower diameter cups.
Cupholder liner is optional and should be printed in TPU or some other flex material.