Thingiverse
RC Tank Target holder by Gringotuerto
by Thingiverse
Last crawled date: 4 years, 2 months ago
This is a holder for the RC Tank target sold by LegoDEI on Etsy:https://www.etsy.com/listing/887629159/modular-ir-target
This is a simple stand to hold it upright, and leaves room for the connectors on the back.
The holes are sized for #1 screws, and you should also put a nylon washer under the screws to prevent stressing the board or shorting anything on it.
I printed it on Form3 with Tough2000 Resin. The holes fit a #1 screw reasonably tightly, but this could vary a lot depending on printer. According to tap/die chart, a #53 jobber drill bit should be appropriate to prepare the hole for a #1 screw, if it comes out too tight.
This is a simple stand to hold it upright, and leaves room for the connectors on the back.
The holes are sized for #1 screws, and you should also put a nylon washer under the screws to prevent stressing the board or shorting anything on it.
I printed it on Form3 with Tough2000 Resin. The holes fit a #1 screw reasonably tightly, but this could vary a lot depending on printer. According to tap/die chart, a #53 jobber drill bit should be appropriate to prepare the hole for a #1 screw, if it comes out too tight.