Thingiverse
RC Springer tugboat
by Thingiverse
Last crawled date: 5 years, 8 months ago
https://www.youtube.com/watch?v=w8N3QwnZDAI
Printed in PLA except for the motor mount, which is PETG.
Expect over 60 hours of printing to finish this. This is a fairly hard to build boat.
Hardware used:
"Brushless Motor Waterproof 3650 2300KV Brushless Motor with 60A ESC Combo Set for 1/10 RC Car Truck"
"4mm Drive Shaft w Propeller and Universal Joint for RC Boat" Use the 9.5mm OD tube version.
Standard servo
4channel surface radio
Shorty 2s 4600mah hardcase battery
about 1.5kg of wrapped pennies for weight
I used waterproof paint, rather poorly.
This motor combination is rather overpowered, see the video. A more normal motor would be a 540 crawler motor and 6v batteries.
200x250x200 is the minimum printer size for this model.
Printed in PLA except for the motor mount, which is PETG.
Expect over 60 hours of printing to finish this. This is a fairly hard to build boat.
Hardware used:
"Brushless Motor Waterproof 3650 2300KV Brushless Motor with 60A ESC Combo Set for 1/10 RC Car Truck"
"4mm Drive Shaft w Propeller and Universal Joint for RC Boat" Use the 9.5mm OD tube version.
Standard servo
4channel surface radio
Shorty 2s 4600mah hardcase battery
about 1.5kg of wrapped pennies for weight
I used waterproof paint, rather poorly.
This motor combination is rather overpowered, see the video. A more normal motor would be a 540 crawler motor and 6v batteries.
200x250x200 is the minimum printer size for this model.