RC plane landing gear by GabrielCrowe

Last crawled date: 2 years, 11 months ago

These are a set of landing gear designed to be attached to foamboard planes. I made these after I found that the hanger wire landing gear were too weak and just tore through the foam wings.
The axles can be made out of short pieces of hanger wire that are bent on the ends to keep them attached to the frame. The back wheel strut is designed to be glued onto the outer foam or built into the back structure of the plane. The front two wheel struts come with three clips that should be slid into a cut slot in the bottom of the plane wing so that they can clip onto the struts base. Glue can be used on these joints to keep them in place.
These should be fairly strong and lightweight, but I am still in the middle of testing. If you have any problems or questions, just message me.