Thingiverse
RC Plane Hinge (uses paper-clip for hinge) by Painless360
by Thingiverse
Last crawled date: 4 years, 5 months ago
This is a simple hinge that you can make to support elevators, ailerons or flaps.
Each side for gluing is 20x30mm. but the smaller hinges are less. See the files for various types and designs. Hopefully there is one that will fit your needs!
You may need to use a 1mm drill to open out the holes for the paperclip wire depending on the way your printer prints the model..
Each side for gluing is 20x30mm. but the smaller hinges are less. See the files for various types and designs. Hopefully there is one that will fit your needs!
You may need to use a 1mm drill to open out the holes for the paperclip wire depending on the way your printer prints the model..