Raven Cane Handle for Umbrella. by Swift2568

Last crawled date: 3 years ago

update 10-27-17 8:45 am Fresh off the printer, 2.0 looks perfect. It's a little rough where the part touched the print bed, but I can sand that later.
Update 10-26-17 2:30 pm - I pulled a new Skull, and did some remixing. I think the result will be better. I'm calling it 2.0.
Update 10-26-17 9:00am - Gotta be honest, I am not happy with this part. The skull is too small, the base is too big, and there is too much extra material between base and skull. I'll be doing some editing.
I have an umbrella that is long enough to use as a cane. It has a straight handle. With Mary Poppins in mind, i figured I'd print and paint one of these guys for the end. My plan is to find a piece of threaded rod to connect umbrella handle to skull. I hollowed out the skull so that I can fill it with epoxy to hold the bolt or rod. I have PC-7 in mind, but any 2 part that doesn't get too hot should work. I'll be printing in PLA, painting in acrylic, and then it'll get about 4-6 layers of rattlecan clear coat. I don't know how well this will work, so wait until i finish mine before you try one.