Thingiverse
ratcheting toothpaste squeezer v4
by Thingiverse
Last crawled date: 5 years, 9 months ago
this work by ratcheting as you tighten up the tube (by turning the knob)
i used supports, of where there is only i tiny bit.
after assembly work in the ratcheting part because there is a little bit of support under the ratcheting levers.
you could try to print without supports, but i havent.
there is turning direction indicator on the opposite end of the turning rod.
i used supports, of where there is only i tiny bit.
after assembly work in the ratcheting part because there is a little bit of support under the ratcheting levers.
you could try to print without supports, but i havent.
there is turning direction indicator on the opposite end of the turning rod.